主页 > 协会标准 > ASTM 美国材料与试验协会 > ASTM D5171-2000(2006) 塑料熔合法兰按扭耐冲击的标准试验方法

ASTM D5171-2000(2006) 塑料熔合法兰按扭耐冲击的标准试验方法

作者:标准资料网 时间:2013-04-19 18:55:10  浏览:3   来源:标准资料网
下载地址: 点击此处下载
【英文标准名称】: Standard Test Method for Impact Resistance of Plastic Sew-Through Flange Buttons
【原文标准名称】: 塑料熔合法兰按扭耐冲击的标准试验方法
【标准号】: ASTM D5171-2000(2006)
【标准状态】: 现行
【国别】:
【发布日期】: 2000
【实施或试行日期】:
【发布单位】: 美国材料与试验协会(US-ASTM)
【起草单位】: D13.54
【标准类型】: (Test Method)
【标准水平】: ()
【中文主题词】:
【英文主题词】: button;impact resistance;strength
【摘要】: This test method may be used to determine the ability of a button to resist breaking under impact, for example in pressing the end item, which could cause the button to fail. Note 18212;In the development of this test method it was found that the following factors influenced the ability of a button to resist failure under impact conditions: resin formulation, shape ligne size, thickness, number and spacing of holes. Buttons may also pass this test but fail during the pressing of a garment due to the presence of heat during pressing. 5.1.1 If there are differences of practical significance between the reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, test samples should be used that are as homogeneous as possible, that are drawn from the material from which the disparate rest results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias. Test Method D 5171 for the determination of the impact resistance of buttons may be used for acceptance testing of commercial shipments of buttons but caution is advisable since information is lacking on precision.1.1 This test method covers the determination of impact resistance of plastic sew-through flange buttons.1.2 The values stated in either acceptable metric units or other units shall be regarded separately as standard. The values expressed in each system may or may not be exact equivalents: therefore, each system must be used independently of the other, without combining values in any way.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
【中国标准分类号】: J15;G33
【国际标准分类号】: 61_040
【页数】: 3P.;A4
【正文语种】:
TAG关键词: 协会标准 行业标准 ASTM 美国材料与试验协会 ASTM 
下载地址: 点击此处下载